Precautions for installation
WARNING
Do not lay the power supply cord across any path where vehicles or
people are likely to walk on it drive over it. The insulation might be
damaged and expose wires which can cause electrical shock.
WARNING
Position the power supply cord where nothing will damage the cord
or break the insulation, e,g., Strapping Coil. A damaged cord can
cause an electrical shock. Replace the cord if the insulation
becomes frayed or broken.
WARNING
Do not handle the power supply cord or power plug with wet hands.
You may receive an electric shock.
WARNING
Handle the polypropylene strapping with care. The sharp edges on
the straps could cut your hands.
WARNING
Lock the casters unless the machine is being moved.
WARNING
Make sure to push the machine in order to move it. Do not pull on the
machine. Pulling on the machine may cause injury.
WARNING
Do not modify the machine. Modifications lead to machine malfunctions
and may cause injuries.
WARNING
Make sure to connect the ground wire.
WARNING
Make sure to connect the power plug to a power outlet that is connected
with a leakage breaker.
CAUTION
Allowing water or oil to come into contact with the electrical wiring
inside the machine can cause a malfunction.
CAUTION
Use the specified cable for power cord.
CAUTION
Disconnect the power plug and wind the cord up when you need to
move the machine.
CAUTION
Do not move the machine b
ullin
on the
ower cord, as the
ower cord
ma
become disconnected, or broken.
CAUTION
Do not
erform an
work not s
ecified in this manual.
－５－
To Next Page
Loading...
