Straumann CARES Scan CS2 - 2 Intended Use

3
2. INTENDED USE
The Straumann
®
CARES
®
Scan CS2 is a 3D scanner of high precision for objects
of the dental area. It is used for 3D measurements of single preparations, abut-
ments, models of the jaw with up to 14 elements, and different impressions.
Together with the corresponding software, the scanner gives dental technicians
the ability to scan models, design a restoration (crown, bridge, abutment, etc.
in a wide range of materials) and send the resulting data file directly to the
manufacturing facility.
Notes
p The surface of the materials must be scannable and therefore it must be
matte (not shiny/reflecting).
p In addition, the surfaces should have a homogeneous color gradient.
Please note
Practitioners must have appropriate knowledge and instruction in the handling
of the Straumann product described herein (“Straumann Product”) for using the
Straumann Product safely and properly in accordance with these instructions.
The Straumann Product must be used in accordance with the instructions for
use provided by the manufacturer. It is the practitioner’s responsibility to use
the device in accordance with these instructions for use and to determine if the
device fits to the individual patient situation.
The Straumann Product is part of an overall concept and must be used only
in conjunction with the corresponding original components and instruments
distributed by Straumann USA, LLC, its ultimate parent company and all affiliates
or subsidiaries of such parent company (“Straumann”), except if stated other-
wise in these instructions. If use of products made by third parties is not recom-
mended by Straumann in these instructions, any such use will void any warranty
or other obligation, express or implied, of Straumann.
Validity
Upon publication of these instructions, all previous versions are superseded.