Lisa Compact 16
4
Configuration
The Lisa Compact comes with default settings. The most important are the network settings. By default
DHCP is used.
The default settings on the Lisa may not be what is needed for your specific application, or they may
have to be updated during use. This section describes the available configuration methods.
4.1 Configuration platform
Update the configuration during use, when the Lisa is in the field, is best done remotely. Therefore the
Lisa by default retrieves its configuration via the network from a remote location (online configuration
platform or server).
Streamit Device portal is the default configuration platform and recommended for use with the Lisa.
However, the Streamit Audio Distribution Platform, or a custom-built platform, can also be used.
The most common configurations settings (e.g. list of presets) can be changed on the platform side and
get communicated to the device when this performs a configuration update (see When is the
configuration updated? for detailed information).
The configuration platform does not allow you to change the IP settings, see Configure the network
settings for this.
4.2 When is the configuration updated?
It is important to realize when and from where the configuration of the Lisa is actually updated. This
depends on the operation mode of the Lisa. Three modes are defined, which determine where the
configuration of the Lisa comes from and how it is updated:
Source of the configuration
When the Lisa retrieves its
configuration:
·
At startup (either power on or
restart)
·
When a task is scheduled with
this command (see Task
scheduling)
·
When the update configuration
command is sent to the Lisa
(see Commands)
To Next Page
Loading...