Streamit Lisa Compact - 4.3 Alternative Configuration Methods; 4.4 Configuration from SD card

Lisa Compact 17
Configuration mode
Source of the configuration
Update
2
Custom-built platform, or
Streamit Audio Distribution
Platform
When the Lisa retrieves its
configuration:
· At startup (either power on or
restart)
· When a task is scheduled with
this command (see Task
scheduling)
· When the update configuration
command is sent to the Lisa
(see Commands)
3
Fixed on-board settings
Using one of the Alternative
configuration methods
In all operation modes the Lisa can start by reading a configuration file from the SD card (see
Configuration from SD card).
4.3 Alternative configuration methods
Next to using a configuration platform to update the settings on the Lisa, the following methods are
available to configure Lisa devices:
· Using the Lisa Configuration Tool
· Via a configuration file on the SD card in the Lisa
· Via a Telnet client
The recommended configuration interface for the Lisa devices is the Device portal web-interface. By
default, all Streamit devices will get their configuration from the Streamit Device portal.
4.4 Configuration from SD card
The Lisa can load a configuration from the SD card. This can be very useful when a large number of
devices needs to be configured. The configuration file is loaded onto the SD card and the SD cards are
then inserted in the Lisa. This section explains in detail how configuration from SD card works, which is
also depicted schematically in the image below.
In every operation mode (see When is the configuration updated?) the Lisa will check during a
configuration update (either at startup or when executing a configuration update task), whether a
configuration file is available on the card. When that is the case, the settings from the configuration file
will be applied.