Lisa Compact 69
Required codec not activated
The audio stream or playlist entry has an audio
format that is not supported by this edition of the
Lisa
RTC power failure detected. Backup battery empty
or missing.
It is highly recommended to exchange the battery
when the issue persists.
Running task was interrupted
The running task (e.g. up) is interrupted from
another scheduled task. Currently, this only applies
to the playlist update. In upcoming release could
apply to other tasks as well.
Schedule update failed (error <id>). Old schedule
kept - <INFO>
Schedule update failed, see Table with error codes
for information and table below for <INFO>
Schedule updated - <INFO>
The schedule update was completed successfully.
See table below for <INFO>.
Schedule updated (!) <INFO>
Non fatal issues occurred, e.g. a task has execution
time in the past, or a task is incomplete (i.e.,
platform did not generate the task according to
requirements). See table below for <INFO>.
Debug message that can be enabled run-time to
confirm the scheduler thread is running
Scheduler extra debug message
Debug message, not in use.
Serial flash access error
Failure to read/write schedule and preset
information. Hardware issue if error persists
Software update check failed
RSU enabled but device fails to connect to update
server or does not get correct info file.
Software update is required, but the Lisa cannot
complete the update. It cannot download the
software file or the downloaded software file is not
correct.
Trying configuration via failover resource
Failure to connect to or resolve the configuration
resource. At least one failover configuration
resource has been configured and the Lisa will try
configuration from there.
To Next Page
Loading...
