SECTION VI
THE BODY
It is important to inspect the Vulcan body for any cracks. Be sure to thoroughly check
around the charge contacts. Cracked bodies must be replaced to maintain the Vulcan's
hermetic integrity and safety ratings.
Streamlight strongly recommends that any cracked Vulcan bodies be returned to the
factory for proper replacement. Streamlight will vacuum test for proper hermetic integrity
and compliance with applicable safety rating requirements.
Note: Paddle style switch versions are no longer available.
Note: There is a pressure vent located between the charge contacts of the Vulcan. The
very small opening of this vent must be kept free of debris, dirt and residue. Replace the
valve plug (protective cap) if it is missing.
Valve Plug
Check for Cracks.
Important Note
: When mounting or repairing the charge rack and the charge contact
screws in the body, Do Not Use anaerobic thread locking compounds (Loctite®, etc). A
chemical reaction caused by the curing of these compounds destroys the molded plastic
and will void the factory warranty.
- 29 -
To Next Page
Loading...
