STREETEC autoleveling - Alignment Confirmation and General Settings; Settings; Compressor Control Settings

Settings
Regulation
• Thepressure/heightvalueis ‚overrun‘ and controlled
‚fromabove‘.Thisisimportantforvehicles/chassisthat
aredifculttocontrol.
• Control accuracy
• If ‚Rise onStart‘ is activated, the vehicleis adjusted
to the normal ride height [RIDE] when the ignition is
changed.
• When pressure compensation is activated, STREETEC
autoleveling attempts to regulate as small a pressure
difference as possible between the left and right sides
within the scope of the possibilities specied by the
vehicle. When using height sensors!
• The control is only carried out axis by axis, the values
on the left and right are always controlled to the same
values if possible..
Drainage
• With activated Drainage an optional usable electrical
Water separator controlled.
• Duration of the Compressor, the according to the water
separator is controlled.
Settings
Cruise Safe
• Durch Aktivieren des Cruise Safe werden einige
Sicherheitsfeatures ergänzt
• Low pressure alarm
• Alarm for too high pressure
• Adjustability lock in case of driving detection by the
integrated acceleration sensor
• Lock adjustability in case of travel detection by a
connected signal (e.g. speed signal).
• Speed at which adjustability is deactivated (with
V-signal connected and calibrated)
• Lock adjustability in case of travel detection by
handbrake signal (12V or ground)
• Offset of the display to the actual driving pressure
• Limiting pressure front axle
• Limiting pressure rear axle
64 65