Need help?Do you have a question about the STREETEC autoleveling and is the answer not in the manual?
Technical specifications and physical dimensions of the Electronic Control Unit (ECU).
Technical specifications and physical dimensions of the touchscreen control panel.
Technical specifications and physical dimensions of the STREETEC valve4 block.
Technical specifications and physical dimensions of the water separator component.
Technical specifications and physical dimensions of the pressure sensors.
Procedures for determining the optimal mounting location for height sensors.
Guidance on choosing the right hole for the coupling rod in the sensor arm.
Step-by-step instructions for adjusting the coupling rod length.
Verifying the working range of the height sensors after installation.
Technical specifications and physical dimensions of the height sensors.
Connecting the main wiring harness to the ECU, valve block, and compressor.
Connecting power, ground, and ignition switch wiring.
Installing the appropriate fuses into the holders.
Connecting the display, buzzer, and optional height sensor harnesses.
Guidelines for routing air lines and tips for proper cutting.
Procedures for assembling and disassembling air lines into fittings.
Initial setup including language and pressure unit selection.
Connecting to smartphone and preparing for calibration.
Option to configure height sensor usage during setup.
Selecting the pressure sensor and initial calibration steps.
Confirmation of calibration and setup for multiple users.
Selecting user profiles and understanding the main interface.
Display variations and selection of vehicle height/ride modes.
Adjusting pressure and height with/without height sensors.
Manual control with sensor data and initiating vehicle leveling.
Confirmation of alignment and general device settings.
Settings for managing the air compressor's operation.
Control parameters for pressure/height regulation and compressor drainage.
Safety features for driving assistance and alerts.
Adjusting display, PIN protection, and using sensor testing tools.
Procedures for calibrating the system and resetting settings.
General| Brand | STREETEC |
|---|---|
| Model | autoleveling |
| Category | Control Systems |
| Language | English |
To Next Page