17
Operation (continued)
1.7 Set Description name: You can set your own name for this Description.
NOTE: The change of this description will not change “Push Notification” name & SSID
1.8 Reset to Default: Pressing “Reset to Default”, will restore the functions to default settings and LED indicator on the
unit will flash quickly in RED light. Please wait about 3 minutes until the RED light changes to a slow flash.
□ Press “Reset to Default”, then press “YES”, the camera will restore the functions to the default settings.
□ LED indicator on the product will flash quickly in RED. Wait about 3-4 minutes until the RED light changes to a slow flash.
NOTE: If you click ”PIR Notification” and there is
no micro card inside the unit when motion is
triggered, it will send PIR (motion) Notification
signal continuously to your smart phone until there
is no more motion detected
To Next Page
Loading...