Strobel 141-40 - Default Chapter; Table of Contents

3 BA_141-30-40_A6-7_140416_en
Operating Instructions
STROBEL – Single Thread Overseam Machines
Class 141-30, 141-40
Contents
1 General notes on safety ............................................................................................ 4
2 General ..................................................................................................................... 6
2.1 Operating instructions ..................................................................................... 6
2.2 Class identification, serial number and orientation of the machine ................. 6
2.3 Range of application and intended use .......................................................... 6
2.4 Technical Data ................................................................................................ 7
3 Installation and putting into service ........................................................................... 8
3.1 Unpacking the machine .................................................................................. 8
3.2 Installation ...................................................................................................... 8
3.3 Sense of rotation (Fig. 2) .............................................................................. 10
3.4 Motor drive via V-belts .................................................................................. 10
3.4.1 Tensioning the V-belt ....................................................................... 10
3.4.2 Positions of the machine .................................................................. 11
3.5 First lubrication (Fig. 6 and Fig. 7) ................................................................ 13
4 Instructions for use .................................................................................................. 15
4.1 Needles and threads (see chart, point “2.4 Technical Data”) ....................... 15
4.2 Inserting the needle (Fig. 8) .......................................................................... 15
4.3 Threading and thread course (Fig. 1 and Fig. 8) .......................................... 16
4.4 Thread tension .............................................................................................. 17
4.5 Setting the stitch length ................................................................................ 17
4.6 Adjustment of material guide ........................................................................ 18
4.7 Inserting and removing the material (Fig. 11) ............................................... 20
5 Machine maintenance ............................................................................................. 21
5.1 Oil drain pipe ................................................................................................ 22
6 Variable sewing tools .............................................................................................. 24
7 Optional extras ........................................................................................................ 28
7.1 Control panel ................................................................................................ 28
Subject to change without prior notice