43 BA_VEB100-2-4-5_A5-3_230118_en.doc
Skip a loop
Possible reasons:
- Incorrectly adjusted looper
- Loop stroke/needle stroke incorrectly adjusted, therefore loop size (too
small/too large) may not be suitable
- Chaining finger damaged or altered
- Incorrectly set or altered cloth retainer or cloth retainer pressure
Solutions:
- Rotate the machine by hand, check the looper movement; usually the
cause can be seen.
- Check the settings, correct if necessary and/or replace any damaged parts.
- If necessary, change the threading at take-up
The machine does not start even though the indicator lamp
of the main switch is on.
Possible reasons:
- Thread trimmer not in final position, microswitch is locked
- Control box error
- Mechanical damage, machine is blocked
Solutions:
- Turn the machine off and back on again. Check the basic position of the
blade. Check the programming
- Eliminate any mechanical faults and, if necessary, call the customer service.
Markings or damage to the sewing material
Possible reasons:
- Feed dog gearing is not suitable
- Plunger shape is not suitable for the sewing material
- Cloth retainer, pressure is set too strongly
- Presser foot pressure has been incorrectly adjusted or lift-off is blocked.
- Damaged sewing parts (lower side of stitch plate!)
- Needles or thread thickness not suitable
Solutions:
- Replace the feed dog or plunger
- Check the presser foot, sewing parts and their functionality, replace any
damaged parts and/or repolish them if necessary.
- Choose needles and threads that are suitable for the sewing material
To Next Page
Loading...
Need help?
General
