Name: Strong SRT 2022
Brand: Strong
Rating: 5 (1 reviews)

To Next Page

To Previous Page

2.6 Installing the batteries

Fig. 5

Open the cover on the remote control and insert 2x AAA batteries into the compartment.

The correct position of batteries polar diagram is shown inside the batteries compartment.

1. Open the cover.

2. Insert the batteries.

3. Close the lid.

Warning: The batteries should not be recharged, disassembled, electrically short-

circuited, be mixed or used with other types of batteries.

2.7 Using the remote control and USB adapter

Fig. 6

Please rst insert the USB adapter of the remote control in a free USB port. This USB adapter receives

the RF (radio controlled) signals from remote control. Without this adapter only the Standby button

will work via the IR sensor (infrared). The remote control has an in-built “G-sensor” which is used as

pointer on your screen in the Android mode. This is called as “Air mouse” function and allows you to

move the pointer by moving the remote control through the air.

Note: As this function uses more power as normal pressing of buttons we

recommend using Alkaline batteries to ensure longer operation time

of your remote control. When the batteries are almost empty the LED

indication on the remote control will start blinking for 15 seconds after you

press any button.

Under normal conditions your remote control has been paired with the USB adapter in the factory

and therefore the “Air mouse” function of your remote control will directly work for your IP box. In

case you can only use the q button on the remote control and none of the other buttons have a

function, or in case the red LED on the remote control keeps blinking, it could be that the pairing

between the remote control and the USB adapter is not correct.

In that case you need to pair the USB adapter to the remote control manually:

1. Remove the USB adapter from the USB slot on the IP box.

2. Make sure the IP box is switched ON.

3. Remove the batteries from the remote control and insert them again. The LED on the remote

control starts ashing.

4. Press and hold the OK and

buttons at the same time for a few seconds. The LED on the

remote control ashes more quickly.

5. Insert the USB adapter into a free USB port of the box and wait until the LED on the remote

control stops ashing (g. 6).

6. Now the remote control is paired with the USB adapter.

Questions and Answers:

Need help?

Do you have a question about the Strong SRT 2022 and is the answer not in the manual?

Strong SRT 2022 Specifications

General