on top and bottom of the picture on a 4:3 TV. Combined: shows a mix in-
between. Ignore: shows as it is.
OSD Transparency: To set the OSD transparency from Opacity ~ 50% with 10% steps.
OSD Timeout: Sets the time after which on screen banners and messages disappear. The
range is 3~10 seconds.
HDMI Audio Output: Toggles between PCM and Bitstream output. When PCM is selected, all digital
audio will be converted to stereo audio. Bitstream enables you to listen or
transfer Dolby® Digital/Dolby® Digital Plus* audio to the TV via HDMI or to a
home cinema set.
SPDIF Audio Output: Toggles between PCM and Bitstream output. When PCM is selected, all digital
audio will be converted to stereo audio. Bitstream enables you to listen or
transfer Dolby® Digital/Dolby® audio to a home cinema set through coaxial S/
PDIF. (Not Dolby® Digital Plus.)
Audio Description: AD. Set this option to On if you like to have support of an audio track that
describes the content on screen. Useful for the visual impaired.
Audio Description Volume offset:
Select the volume from the AD audio track.
* Dolby Digital Plus, Dolby Digital and the double-D symbol are registered trademarks of Dolby Laboratories
7.3.3 General Settings
This menu allows you to manage the basic system settings of your receiver.
It consists of the following sub-menus: Auto Standby and Auto Channel Update.
7.3.3.1 Auto Standby
Auto Standby is a new feature that helps you reducing power consumption.
Press pq to highlight the menu Auto Standby and press OK advance.
When set to between 1 to 6 Hours, the receiver will switch to standby if it doesn’t receive any
commands of the remote control during this time. Set Auto Standby to Off to deactivate the
automatic standby function. The default setting is 3 hours.
7.3.3.2 Auto Channel Update
When set to On, the unit will check automatically at the moment of turning to standby if new
channels are available. The next time when switching on, you will be informed if new channels are
on air and prompted to start an auto scan. This way you are always up-to-date with the channel list. If
you select Off, the automatic channel update function is deactivated.
7.3.4 Parental Control
This menu allows you to protect the installation menu and/or channels with a PIN code. You can also
create a new PIN code. Use pq to select Parental Control from the Settings menu and press OK to
proceed. You will be asked to enter your PIN code. (DEFAULT PIN: 0000)
Menu Lock: Locks the installation menu. You can set the Menu Lock to On or Off.
16
To Next Page
Loading...
