7.6 Upgrade by USB
This feature allows you to update the receiver software via the USB port. When a new software is
available for your receiver, it can be downloaded from our website www.strong.tv.
Place the software file (unzipped) in the root directory of your USB storage device (HDD, memory
stick etc.) and connect the device to the USB port of the receiver. First a message box will appear that
a USB device is found. After a short time a message will appear on screen again with the message
New software available. Select OK to start download and update immediately. When ready, the unit
will reboot automatically.
NOTE: If, after a software update, the receiver should behave in an unexpected
way, please perform a factory reset as well. See chapter 7.1.4..
WARNING: After an update the receiver restarts automatically. During the upgrade
process NEVER disconnect the receiver from the mains or switch off the
power! Doing so might damage your receiver and will void warranty!
WARNING: Old channel list and favourites will be overwritten.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline or send email to our Support via www.strong.tv. Do NOT try to
open or disassemble the receiver. It may cause a dangerous situation and warranty will be void.
Problem Possible cause What to do
LED indicator and
LED display are not
switching on.
The mains lead is unplugged.
Power switch at rear panel is
set to OFF.
Check the mains plug. Switch main
power to ON.
No signal found The antenna is disconnected
The antenna is damaged/
misaligned
Out of digital signal area
Active antenna requires
to switch ON the antenna
power/external power
Check the lead of the antenna
Check the antenna
Check with your dealer
Switch the antenna power of the
receiver ON/connect external power
21
To Next Page
Loading...
