EasyManua.ls Logo

Strong SRT24HE4203 - Specifications; Audio and Video Specifications

Strong SRT24HE4203
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
Problem Possible cause and solution
Ghost Ghosts are caused by the television signal following two paths. One
is the direct path, the other is reected from tall buildings, hills, or
other objects. Changing the direction or position of the antenna may
improve the reception.
Radio frequency interference This interference produces moving ripples or diagonal streaks, and
in some case, loss of contrast in the picture. Find out and remove the
radio interference source.
Playback of video is causing picture
freeze/macro blocks or similar
distortion, especially on HD content
Read/write speed of your USB device could be too low. Make sure to
use a USB storage device with sucient speed and space. Pen drives
(USB sticks) may not support sucient speed.
No signal or weak signal,
intermittent reception
a) Cables might have loosened; moisture might have
entered into cables or connectors, heavy rain at present
or heavy storm at present. Check the cable connections,
LNB and other equipment connected between the LNB
and the receiver, or peak the dish. Wait for rain/storm to
subside. Ask a local satellite specialist for advice.
b) The satellite dish is not pointing at the (correct)
satellite(s). Adjust the dish. Ask a local satellite specialist
for advice.
c) Satellite dish is too small, trees or buildings in path.
Change to a larger dish or change position of dish.
d) Signal is too strong, dish is oversized. Connect a signal
attenuator to the LNB input. Ask a local satellite specialist
for advice.
Bad picture / blocking error during
heavy rain
Heavy rain will attenuate satellite signals, below a certain level
blocking will occur.
Make sure your dish installation is up to standards to minimize rain
eects. When in doubt, ask a local satellite specialist for advice.
If the TV turns o after plugging a
cable into any connector
Again, turn on the TV.
NOTE: If the problem persists after these solutions, please contact your local support centre or send a
support mail via our website www.strong.tv.
11. SPECIFICATIONS
Audio
Audio Output: 2 x 8 W
Video
Channel coverage: DVB-T/T2: 174 MHz-230 MHz; 470 MHz-860 MHz
DVB-C: 113-858 MHz
DVB-S/S2: 950 MHz-2150 MHz
System: DTV: DVB-T/T2, DVB-S/S2, DVB-C
ATV: PAL/SECAM (BG/DK/1)
AV: PAL, NTSC, SECAM

Related product manuals