Time Offset: This setting allows you to change the time zone (or GMT) if necessary. Press
OK button to open the pop-up menu and use pq to make your selection.
Confirm with OK.
Region: This setting allows you to change the Country. Consider that this will also
affect the time if you select a country with a different GMT. Press OK button
to open the pop-up menu and use pq to make your selection. Confirm with
OK.
Time format: This setting allows you to view the time in 24H or 12H format. Press OK
button to open the pop-up menu and use pq to make your selection.
Confirm with OK.
7.3.5 Timer
This menu allows you to set the timers according to your needs, without being tied to the times set by
the EPG function. In this menu you can set 3 different types of timers: Channel Change, Power On and
Power Off. To create a new event press GREEN button. The available settings are listed below:
Mode: This option allows you to set the type of timer to activate. Use t u button
to choose from the following options: Channel Change to tune the receiver
to the channel and time set in the following settings, Power Off to put the
receiver on standby at the set time and Power On to switch on the receiver at
the time and on the set channel.
Channel: Here you can set the channel to be displayed. Use t u buttons to set the
channel or press OK button to display the entire channel list, use pq to
select the channel and confirm with OK.
Start Date: Use 0~9 buttons to set the time to activate the timer.
Reminder: Here you can set the advance in which to signal the start of the timer. Use
t u button to set the time.
Cycle: This option allows you to establish the repetition of the event. The options
are: Every Day to repeat the operation every day, Every Week to repeat the
operation every week, One Time to activate the event are the day and date
set. Press t u to make your selection.
The set data will be saved when you exit the menu. Press EXIT button and select OK. Selecting Cancel the
timer will not be activated.
To delete a timer press the RED button, to delete one or more timers press the YELLOW button. For both
operations, confirm the operation by selecting OK or reject by selecting Cancel.
7.3.6 Lock
Access to this menu requires the insertion of the PIN code as it allows the modification of privacy
settings. In fact here it is possible to change the PIN code and set the Parental Rating level.
The available settings are shown below:
Parental Rating: This setting allows you to enable (or disable) the Parental Rating function.
Whenever a channel reports a rating higher than the one set, the receiver will
block the content and will request the PIN code to be entered. Entering the
correct code will unlock the channel. Available settings are: PG-18, PG14, PG7
and None to disable the lock. Press t u to make your selection.
New Password: Use 0~9 buttons to set the new PIN code.
Confirm Password: Use 0~9 buttons to confirm the new PIN code.
16
To Next Page
Loading...
Need help?
Demodulator
Video
Audio