To Next PageTo Next Page
Need help?Do you have a question about the Struck SIS3153 and is the answer not in the manual?
General| Brand | Struck |
|---|---|
| Model | SIS3153 |
| Category | Recording Equipment |
| Language | English |
Details the SIS3153 USB register space and driver access calls.
Provides an offset-based map of registers within the SIS3153 USB register space.
Explains the USB registers including control, status, and ID registers.
Details the Control/Status register for board properties and status monitoring.
Describes the register storing module identification and firmware revision levels.
Holds the serial number of the module and related flags.
Describes the register for controlling front panel inputs/outputs logic levels.
Used to control UDP data packets and ethernet interface setup.
Controls basic properties of the SIS3153 board as a VME master.
Contains status information for the last VME Cycle, including error codes.
Reflects the status of VME IRQ lines for interrupt checking.
Details Windows driver calls for VME Bus interaction and supported VME cycles.
Presents measured data rates for internal space access via USB.
Shows VME data rates measured through USB connections.
Shows VME data rates measured using a Chrislin VME Memory.
Presents VME data rates measured with a SIS3305 ADC.
Details the function and status indication of the six front panel LEDs.
Explains the function of nine red surface mount LEDs indicating board status.
Describes the CON100 JTAG header for firmware programming via JTAG.
Explains the use of rotary encoders for defining VME slave addresses.
Details the 8-switch DIP for system controller, reset, and slave addressing.
Explains jumper settings for LEMO input/output logic levels (NIM/TTL).
Details the UART interface for debugging the FX3 controller and forcing bootloader.
Explains the different boot modes for the FX3 controller based on jumper settings.
Discusses considerations for using multiple SIS3153 modules as VME masters.
Explains how the SIS3153 acts as a VME system controller and clock generator.
Details proper settings for bus grant, mastership, and arbitration timeouts.
Details Windows software, including a CERN ROOT based GUI for Ethernet.
Describes Linux software, including ROOT applications and SIS3150 sisusb driver.
Lists the current consumption for the USB3 interface across different voltage rails.
Discusses the recommended practical length limit for USB 3.0 cables.
