Structural Concepts G Series - General Layout, ContD: Led Light Switch and Fixtures; Led Removal; Replacement

GENERAL LAYOUT, CONT’D: LED LIGHT SWITCH AND FIXTURES / LED REMOVAL & REPLACEMENT
13
Note: Model GHSS476HRD.5718 Is
Shown. It May Not Exactly Reflect
Every Feature Or Option Of Your
Particular Model.
Model GHSS476HRD.5718
Shown Partially Disassembled
For Illustrative Purposes Only.
LED’s Oval Form
Plug’s
Oval Form
--- LED Plug & Light Fixture ---
Retaining
Springs
1. LED Style Light Switch
x Light switch is at case rear.
x See previous page for illustration.
2. LED Style Light Fixtures
Removal of faulty LED light:
x LED lights rarely require change-out.
x To remove faulty LED light, simply grasp light
near retaining spring and carefully pull away
from its spring. Disconnect plug from LED’s
socket.
x Contact Structural Concepts’ Technical Service
Department for replacement parts (see the
Technical Service section of operating manual
for information).
Replacement of LED light:
x To replace LED light fixture, simply insert new LED
light at proper position (socket must be near plug).
Carefully snap into metal springs so LEDs are held
firmly in place.
x Note: LED light and plug must be connected in a
specific manner or they will not work.
x Make certain oval edge of plug connects to oval
edge of LED light.
x See illustrations at lower left.