Structural Concepts G Series - Page 4

4
PRECAUTIONS
x Following are important precautions to prevent damage to unit, merchandise or product.
x Please read carefully!
CAUTION! LAMP REPLACEMENT GUIDELINES
LED lamp replacements must meet factory specifications.
CAUTION
CAUTION! ADVERSE CONDITIONS / SPACING ISSUES
x Performance issues caused by adverse conditions are NOT covered
by warranty.
x End panels must be tightly joined or kept at least 6-inches away from
any structure to prevent condensation.
x Unit must be kept at least 15-feet from exterior doors, overhead HVAC
vents or any air curtain disruption to maintain proper temperatures.
x Do not expose to direct sunlight or heat source (ovens, fryers, etc.).
x
Keep at least 8-inch clearance above unit for air discharge
(self-contained units only).
CAUTION
CAUTION! POWER CORD AND PLUG MAINTENANCE
Risk of electric shock. If cord or plug becomes damaged,
replace only with cord and plug of same type.
OVERVIEW / TYPE / COMPLIANCE / WARNINGS / PRECAUTIONS / WIRING / PLUGS - PAGE 2 of 2
CAUTION! GFCI BREAKER USE REQUIREMENT
If N.E.C. (National Electric Code) or your local code
requires GFCI (Ground Fault Circuit Interrupter) protection,
you MUST use a GFCI breaker in lieu of a GFCI receptacle.
WIRING DIAGRAM FORMAT & LOCATION
x Each case has its own wiring diagram folded & in its own packet.
x Wiring diagram placement may vary; it may be placed near ballast
box, field wiring box, raceway cover, or other related location.
SEAL FLOOR-MOUNTED UNITS TO THE FLOOR
x
Thoroughly clean floor to assure a secure seal!
x
Base frames or fixed (non-removable) cladding,
panels and/or splash guard brackets must be
sealed to floor with silicone that meets or
exceeds food grade NSF/ANSI Standard 51.