Stryker Isolibrium 2971 - Pod Assembly Replacement

EENN
www.stryker.com 2971-109-0 01 REV B 1-37
Service
Pod assembly replacement
Tools required:
• Zipper pull tool or equivalent
Procedure:
1. Remove the top cover. See Cover replacement, top on page 1-34 for removal.
2. Unsnap the pillow (H) from the left and right side of the pod assembly (Figure 1-12 on page 1-37). Save the pillow.
3. Separate the six Velcro® connectors holding the foot section gel crib to the pod assembly.
4. Remove the foot section gel crib (F) by lifting upward (Figure 1-12 on page 1-37). Save the gel crib.
Z
Figure 1-12: Gel crib, pillow, and quick disconnect fitting
5. Disconnect the quick disconnect fitting (Z) (Figure 1-12 on page 1-37).
6. Remove the two retaining pins (A) from the hose quick connection from the foot box assembly (Figure 1-13 on page
1-38). Save the pins.