11
W
ARNING IF THE LIGHT SOURCE IS NOT IN STANDBY MODE PRIOR TO
REMOVING THE CABLE, THE HIGH INTENSITY LIGHT WILL SHINE
DIRECTLY OUT OF THE LIGHT SOURCE BRIEFLY BEFORE TURNING
OFF, POSSIBLY CAUSING INJURY TO THE USER’S EYES.
Note The Light Source will default to Standby mode when a light cable
is inserted.
System Operation
Note Before operating the L9000, see the “Setup and Assembly” section
of this manual.
Powering the System On and Off
To power on the L9000:
Press the power switch on the front panel. The LCD will indicate that the unit is
in Standby mode.
Note The light will not illuminate unless a light cable is installed in the
cable port.
To power off the L9000:
1. Put the light source unit into Standby mode.
2. Disconnect the light cable from the L9000 console.
3. Run the fan for at least one minute to cool the unit.
4. Press the power switch on the front panel of the L9000.
W
ARNING TO ALLOW FOR ADEQUATE COOLING, NEVER BLOCK THE REAR OR
SIDE FAN VENTS. FAILURE TO FOLLOW THIS INSTRUCTION MAY
RESULT IN DAMAGE TO THE L9000 OR A POSSIBLE FIRE.
To Next Page
Loading...
Need help?
General
