• Do not load the IV pole above the safe working load of 40 lb (18 kg).
• Do not load an individual IV pole hook above the safe working load of 20 lb (9 kg).
• Always secure the lifting pole in the mounting bracket before you adjust the patient helper.
• Always remove the patient helper before transporting the product.
• Always make sure that the patient helper mounting bracket is secure before use.
• Do not load the oxygen bottle holder above the safe working load of 45 lb (20.4 kg).
• Always unplug the power cord from the wall outlet when large spills occur near the circuit boards, cables, and motors.
Remove the occupant from the product, clean up the fluid, and inspect the product. Fluids can cause unpredictable
operation and decreased functionality of any electrical product. Do not return the product to service until dry and tested
for safe operation.
• Always wipe down with clean water (or 70% isopropyl alcohol, if using VViirreexx® TB) and dry each product after
disinfecting. Some disinfectants are corrosive in nature and may cause damage to the product. If you do not rinse and
dry the product, you may leave a corrosive residue on the surface of the product. This corrosive residue could cause
premature degradation of critical components. Failure to follow these disinfecting instructions may void your warranty.
EN 6 5900-009-001 Rev A.4
To Next Page
Loading...
Need help?
General
