Studer Innotec SA
Quick guide RCC-02/-03
8 V 6.1.0 Quick guide
6.2 CONFIGURATION OF THE XTENDER (INVERTER/CHARGER)
Xtender parameter description
Basic parameters set by means of the potentiomenter in
the XTS
Maximum current of AC source (Input limit)
Type of detection of the grid loss (AC-In)
BATTERY MANAGEMENT AND CYCLE
Charger uses only power from AC-Out
Battery undervoltage level without load
Battery undervoltage dynamic compensation
Battery undervoltage dynamic compensation
Kind of dynamic compensation
Battery undervoltage level at full load
Battery undervoltage duration before turn off
Restart voltage after batteries undervoltage
Battery adaptive low voltage (B.L.O)
Max voltage for adaptive low voltage
Reset voltage for adaptive correction
Increment step of the adaptive low voltage
Battery overvoltage level
Restart voltage level after an battery overvoltage
Use dynamic compensation of battery level (new cycle)
Voltage level 1 to start a new cycle
Time period under voltage level 1 to start a new cycle
Voltage level 2 to start a new cycle
Time period under voltage level 2 to start a new cycle
New cycle priority on absorption and equalization phases
To Next Page
Loading...
Need help?
General
