EasyManua.ls Logo

Stulz CyberCool 2 - 6. Commissioning; 6.1 Filling of the Water Circuit

Stulz CyberCool 2
102 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
68 EN/09.2019/G41  © STULZ GmbH – all rights reserved
cybercool 2 screw original insTrUcTions
6. Commissioning
NOTICE
The unit must be installed and connected in accordance with the chapter on „installation“ before
initial commissioning.
If the water temperature passes under 5°C or if the outside temperature is less than 0°C, you must add an
anti-freezing agent. We recommend to add the following quantities of glycol (indicated as percentage of
weight of the water quantity):
Ethylene glycol Water or outside air temperature
20% until -9,0°C
25% until -12,3°C
30% until -16,1°C
35% until -20,4°C
40% until -25,2°C
45% until -30,8°C
50% until -37,6°C
Propylene glycol Water or outside air temperature
25% until -10,7°C
30% until -14,0°C
35% until -17,6°C
40% until -21,5°C
45% until -26,0°C
50% until -32,4°C
WARNING
Risk of glycol intoxication
Do not swallow ethylene glycol. Ethylene glycol is highly toxic in oral ingestion.
Lethal dose: 0,4 g ethylene glycol/kg body weight, severe intoxication: already at 0,1 ml/kg.
Glycol is absorbed through the skin. Therefore immediately change clothing soaked with glycol.
Wear protective gloves made of rubber.
6.1 Filling of the water circuit
 
It is difficult to produce a homogeneous glycol mixture. You can purchase ready-made glycol mixtures.
 

Related product manuals