Stulz CyberCool 2 - 7.5 Water Circuit

87 © STULZ GmbH – all rights reserved EN/09.2019/G41
cybercool 2 screw original insTrUcTions
Tightness
A lack of water in the circuit is replaced by air, which reduces the heat capacity of the chilled water circuit and
is detrimental to the pump. A level indication at the storage tank, if existant, can give information about chan-
ges of the water quantity.
 
Evaporator

the chilled water outlet temperature at full load.

Another possibility to verify this, consists in the comparison of the chilled water outlet temperature with the
-

In this case the evaporator has to be cleaned chemically.
7.5 Water circuit
Frost protection sensor
Flow sensor



Pump (option)





area.