Stulz CyberCool 2 - Page 86

86 EN/09.2019/G41 © STULZ GmbH – all rights reserved
cybercool 2 screw original insTrUcTions
Removal of a condenser fan
WARNING
Risk of injury by burns and rotation



for each heat exchanger element.


a screwed plug connection in the power line part and two screwed plug connections in the control line part.



Condenser fan

An increased operation current indicates a winding short circuit in the fan motor.
Air filter in the compressor cabinet


using a screwdriver.
Top view
access by removing or tipping up condenser
fans
You must remove a condenser fan for each
heat exchanger element, if the chiller is not

NOTICE

cleaner can damage the fins of
the opposite coil.