81 © STULZ GmbH – all rights reserved EN/09.2019/G41
cybercool 2 screw original insTrUcTions
external reset button
adjustment screw for setting threshold
adjustment lock
HP switch
without delay. Before the restart and after the elimination of
button.
You can change the action value only after having removed
-
A check of the tripping function of the high pressure limiter
-
toring functions via the high pressure sensor, which intervene
-
bears the risk that this one is not exactly readjusted after the
provide sufficient accuracy.
reset button is located inside.
LP switch
stepwise closing the expansion valve of one refrigerant circuit
gauge in the compressor section, whether the low pressure
-
pressor is switched off without delay.
you can reduce the threshold by turning counterclockwise the
adjustment screw on the top side of the pressure switch after
LP switch with scale for threshold and pressure
hysteresis for automatic reset
To Next Page
Loading...
