15 © STULZ SpA . – all rights reserved EN/39B/06.2018
SAL
2.6. Intended and non-intended use
Intended use
STULZ SplitAir3 air conditioners are designed to cool rooms / shelters containing technological
systems. Their use eliminates problems caused by high temperatures, dirt and humidity present in
the area where they are installed. The units of SplitAir3 family are divided in two parts: the motor-
condensing unit must be installed outside the room to be conditioned and it's designed to operate
with compressor always in upright position. The evaporating unit must be installed inside the room
to be conditioned, suitably protected from weather, and it can be positioned horizontally (fixed to the
ceiling) or vertically (fixed to the wall).
The internal side of the room/ shelter must not be accessible to the general public (see EN 60335-
240, paragraph 3.119).
The SplitAir3 conditioners cannot be used outside safety limits specified on the name-plate.
STULZ is not responsible for an malfunctions caused by failure to comply with these instructions.
The operator bears the entire risk.
DANGER
The conditioners may not be used or transported in a position other than that for which they
have been designed. STULZ declines all liability deriving from failure to observe the above.
Non-intended use
The air conditioner cannot be installed in the following areas:
• With strong heat radiation;
• With strong magnetic fields;
• With free flames;
• With fire risk;
• With inflammable products;
• With explosive atmosphere;
• With saline atmosphere;
• With aggressive atmosphere.
For any doubt, please consult the manufacturer.
3. Handling and storage
3.1. Unit receipt
STULZ products are delivered ex-works. All units have been individually inspected in all their
components and been carefully packaged before the delivery.
Immediately inspect the unit upon receipt of the goods.
• Make sure that it has been transported in the correct position. Note any unsuitable shipping
conditions on the shipping document.
• Check that no components are missing, that are presents on shipping document and the integrity
of the conditioner at the moment of the receiving.
• Check that there aren’t any external damages. In case of damages, note them on the shipping
document in the presence of deliverer.
• Hidden damage, that are verified after removal the packing, must always be notified to the shipper
by registered letter within 8 days of receipt of the goods.
To Next Page
Loading...
