Once the fireplace has been brought
close to its final location, please check
that the counterweight cables run in
the groove of the pulleys [photo1].
Unlock the counterweights using the
3mm Allen key [photo2].
Do not forget to perform this
operation before fitting the fireplace
into masonry !
Make sure the window moves
properly ; then raise it to the full
[photo3].
Never tilt more than 90°.
Fitting the upper extension
or the lid
Depending on the option selected,
attach the extension (full opening)
[photo 1] or the cover plate (partial
opening) [photo 2] using the screws
supplied with the stove.
Fitting the smoke outlet
Screws are already in place when you
receive the appliance.
Remove them [photo 3].
Position the seal supplied with the
appliance, it ensures air-tightness
between the smoke outlet and the
hearth body [photo4].
Checking glass movement
Locating the glass protection and smoke outlet
To Next Page
Loading...
