Black plate (163,1)
北米Model "A2440BE-B" EDITED: 2007/ 5/ 7
To adjust the time shown by the clock,
press the “+” button or the “−” button. The
indicated time will change in one-minute
increm ents. If you keep the button
pressed, the rate at which the indicated
time changes will speed up.
To reset the minutes to “00” with a radio
time signal, push the “SET” button.
Information display (2.5-liter
non-turbo model without Na-
vigation System)
NOTE
If your vehicle is a 2.5-liter non-turbo
model equipped with a navigation sys-
tem, refer to the separate “Operating
Instructions for Monitor System”.
Withtheignitionswitchinthe“ON”
position, each successive push of the
“DISP” button toggles the display in the
following sequence:
& Outside temperature indica-
tor
U.S.-spec. models
Instruments and controls
3-41
– CONTINUED –
3
To Next Page
