Black plate (297,1)
北米Model "A2440BE-B" EDITED: 2007/ 5/ 7
desired speed, press the “SET/COAST”
button once. Now the desired speed is set
and the vehicle will keep running at that
speed without depressing the accelerator
pedal.
& Cruise control indicator light
Vehicle with SI-DRIVE
Vehicle without SI-DRIVE
The cruise control indicator light comes on
when the ignition switch is turned to the
“ON” position and goes out after approxi-
mately 3 seconds.
The light comes on when the “CRUISE”
main switch is pressed.
NOTE
. If you press the “CRUISE” main
switch button while turning the ignition
switch “ON”, the cruise control func-
tion is deactivated and the cruise
control indicator light flashes. To re-
activate th e cruise control fun ction,
turn the ignition switch back to the
“Acc” or “LOCK” position, and then
turn it again to the “ON” position.
. If this indicator light and the CHECK
ENGINE warning light/malfunction in-
dicator lamp flash simultaneously dur-
ing driving, have the vehicle checked
by your nearest SUBARU dealer.
& Cruise control set indicator
light
Vehicle with SI-DRIVE
Starting and operating
7-49
– CONTINUED –
7
To Next Page
