PI-5
PRE-DELIVERY INSPECTION
PRE-DELIVERY INSPECTION
1. APPEARANCE CHECK
1) If the vehicle is covered with protective coating,
visually check the vehicle body for damage and
dents.
2) If there is no protective coating, check the body
paints for small areas of damage or stains and re-
pair as necessary.
3) Check the window glass, door glass, and lights
for any cracks or damage and repair or replace the
parts as necessary.
4) Check the plated parts, such as the grilles and
door knobs, for damage or loss of gloss and repair
or replace the parts as necessary.
2. TIRE CHECK
• Check the tire outer faces for any damage.
• Check the tire air pressure by referring to the fol-
lowing table.
3. FUSE INSTALLATION
A vehicle just delivered has no fuse for the room
lamp circuit to prevent battery discharge. Attach a
15 A fuse (A) as shown in the figure.
4. CONNECTION OF AIR CONDITIONER
HARNESS
A vehicle just delivered has its air conditioner har-
ness disconnected to protect the air conditioner
compressor. Connect the harness as shown in the
figure.
5. CHECK THE DOORS FOR LOCK/UN-
LOCK AND OPEN/CLOSE OPERATIONS.
1) Using the key, lock and unlock the door several
times to check for normal operation. Open and
close the door several times for smooth movement.
Tire size Tire inflation pressure
kPa (kg/cm
2
, psi)
Front Rear
205/70R15 200 (2.0, 29) 190 (1.9, 28)
215/60R16 200 (2.0, 29) 190 (1.9, 28)
PI-00001
(A) Unlock
(B) Lock
PI-00002
PI-00070
(A)
(B)
To Next Page
Loading...
