PI-9
PRE-DELIVERY INSPECTION
PRE-DELIVERY INSPECTION
18.CLUTCH FLUID
Check the clutch fluid amount. If the amount is in-
sufficient, check that no leaks are found. Then, add
the necessary amount of the specified fluid.
19.WINDOW WASHER FLUID
Check the window washer fluid amount. If the
amount is insufficient, check that no leaks are
found. Then, add the necessary amount of washer
fluid commercially available.
20.HOOD LATCH CHECK
Retract the hood stay and close the hood. Check
that the hood is securely latched.
21.KEYLESS ENTRY SYSTEM
Check the keyless entry system operations as fol-
lows:
• Fully open all the door windows.
• Remove the key from the ignition switch and
close all the doors including rear gate.
• Press the “LOCK” button on the transmitter once
and check if all the doors are locked, and the haz-
ard light flashes once.
• Press the “UNLOCK” button on the transmitter
once and check if the all doors are unlocked, and
the hazard light flashes twice.
• Close all doors and rear gate, press the “LOCK”
button of the transmitter. Press the “UNLOCK” but-
ton of the transmitter and wait for 30 seconds.
Check that all doors and the rear gate are automat-
ically locked again.
(A) Reservoir tank
(B) MIN level
(C) MAX level
PM-00076
(A)
(B)
(C)
PI-00108
PI-00109
PI-00110
PI-00111
To Next Page
Loading...
