PM-7
PERIODIC MAINTENANCE SERVICES
ENGINE OIL
7) Fill engine oil through the filler pipe up to center
between upper level and lower level. Make sure
that the vehicle is placed level when checking oil
level. Use engine oil of proper quality and viscosity,
selected in accordance with the table in figure.
Recommended oil
API classification
SL or SJ or SH with the words “Energy Con-
serving or Energy conserving II”, CCMC
specification G4 or G5, ACEA specification
A1, A2 or A3, or New API mark displayed on
the container (If it is impossible to get SL or
SJ or SH grade, you may use SG grade.)
Engine oil capacity
Non-turbo model:
Upper level
Approx. 4.0 2 (4.2 US qt, 3.5 Imp qt)
Lower level
Approx. 3.0 2 (3.2 US qt, 2.6 Imp qt)
Turbo model:
Upper level
Approx. 4.5 2 (4.8 US qt, 4.0 Imp qt)
Lower level
Approx. 3.5 2 (3.7 US qt, 3.1 Imp qt)
The proper viscosity helps vehicle get good cold
and hot starting by reducing viscous friction and
thus increasing cranking speed.
NOTE:
• When replenishing oil, it does not matter if the oil
to be added is a different brand from that in the en-
gine; however, use oil having the API classification
and SAE viscosity No. designated by SUBARU.
• If vehicle is used in desert areas with very high
temperatures or for other heavy duty applications,
the following viscosity oils may be used:
API classification: SL, SJ or SH
SAE Viscosity No.: 30, 40, 10W-50, 20W-40, 20W-
50
8) Close the engine oil filler cap.
9) Start the engine and warm it up for a time.
10) After the engine stops, recheck the oil level.
<Ref. to PM-7, INSPECTION, Engine Oil.>
B: INSPECTION
1) Park the vehicle on a level surface.
2) Remove the oil level gauge and wipe it clean.
3) Reinsert the level gauge all the way. Be sure that
the level gauge is correctly inserted and in the
proper orientation.
4) Remove it again and note the reading. If the en-
gine oil level is below the “L” line, add oil to bring
the level up to the “F” line.
5) After turning off the engine, wait a few minutes
for the oil to drain back into oil pan before checking
the level.
6) Just after driving or while the engine is warm, en-
gine oil level may show in the range between the
“F” line and the notch mark. This is caused by ther-
mal expansion of the engine oil.
7) To prevent overfilling the engine oil, do not add
oil above the “F” line when the engine is cold.
(A) Visosity No. and applicable temperature
(B) Preferred
PM-00088
4030150-15-20-30( C)
104865932
10W-30,10W-40
5-4-22( F)
5W-30 (B)
SAE (A)
(A) Oil level gauge
(B) Oil filler cap
(C) Notch mark
(D) Upper level
(E) Lower level
(F) Approx. 1 2 (1.1 Us qt, 0.9 lmp qt)
PM-00082
(A)
(B)
(D)
(E)
(F)
(C)
To Next Page
Loading...
