PI-11
PRE-DELIVERY INSPECTION
PRE-DELIVERY INSPECTION
35.POWER WINDOW OPERATION CHECK
Manipulate the power window switches one by one
to check that each of the power windows goes up
and down with no abnormal noises.
36.BRAKE TEST
Check the foot brake for normal operations.
37.PARKING BRAKE
Check the parking brake for normal operations.
38.AT SHIFT CONTROL
Set the AT select lever to each gear position while
checking that the demanded gear position is cor-
rectly attained.
39.HEATER & VENTILATION
Operate the heater and ventilation system to check
for normal airflow outlet control, air inlet control, air-
flow capacity, and heating performance.
40.AIR CONDITIONER
Operate the air conditioner. Check that the A/C
compressor operates normally and enough cooling
is provided.
41.CRUISE CONTROL
Operate the cruise control system. Check that the
system is activated and deactivated correctly.
42.ATF LEVEL
Check that the ATF level is normal. If insufficient,
check that no leaks are found. Then add the neces-
sary amount of the specified ATF.
43.POWER STEERING FLUID LEVEL
Check that the power steering fluid level is normal.
If insufficient, check that no leaks are found. Then
add the necessary amount of the specified power
steering fluid.
44.FLUID LEAK CHECK
Check the entire areas of the vehicle for any trace
of coolant/oil/fluid leaks.
45.WATER LEAK TEST
Spray the vehicle with water and check that no wa-
ter enters the passenger compartment.
• Before performing the water leakage test, re-
move anything that may obstruct the operation or
which must be kept dry.
(1) RHD model
(2) LHD model
Selector
Position
Gear Position
1st 2nd 3rd 4th
D Yes Yes Yes Yes
3 Yes Yes Yes —
2YesYes——
1Yes———
PI-00112
(1) (2)
P
R
N
D
3
2
1
(A) Level gauge
(B) “HOT” side
(C) Upper level
(D) Lower level
(E) “COLD” side
(F) Upper level
(G) Lower level
(A) Reservoir tank
(B) MIN level
(C) MAX level
PM-00033
(B)
(C)
(F)
(D)
(G)
(E)
(A)
COLD
L
L
HOT
F
PM-00070
To Next Page
Loading...
