• Place “NO FIRE” signs near the working area.
• Be careful not to spill fuel on the floor.
• Reduce the fuel in the fuel tank to less than
3/4 beforehand. Be careful that fuel may spill
when the fuel is more than 3/4.
1) Drain fuel. <Ref. to FU(H4SO 2.0)-38, DRAIN-
ING FUEL, PROCEDURE, Fuel.>
2) Remove the rear seat.
3) Remove the service hole cover.
(1) Remove the bolts (A).
(2) Push the grommet (B) down under the body
and remove the service hole cover.
4) Disconnect the connector from fuel sub level
sensor.
5) Disconnect the quick connector and then discon-
nect the fuel delivery hose, return hose and jet
pump hose. <Ref. to FU(H4SO 2.0)-53, REMOV-
AL, Fuel Delivery, Return and Evaporation Lines.>
6) Remove the bolts which install the fuel sub level
sensor on fuel tank.
7) Remove the fuel sub level sensor.
B: INSTALLATION
Install in the reverse order of removal.
Use a new gasket.
(1) Ensure the sealing portion is free from fuel or
foreign particles before installation.
(2) Tighten the nuts and bolts to specified torque in
the order as shown in the figure.
Tightening torque:
4.4 N
⋅
m (0.45 kgf-m, 3.3 ft-lb)
FU-01126
(B)
(A)
(A)
FU-01143
(A) Jet pump hose
(B) Delivery hose
(C) Return hose
FU-01144
(B)
(C)
(A)
FU-01145
1
6
5
2
4
3
FU-01146
To Next Page
