Instruments and controls/Mirrors
new battery be placed in the
hand-held remote (garage door
opener remote) of the device for
quicker and more accurate train-
ing.
. Turn the ignition switch to the
“ON” or “ACC” position before
programming and/or operating
HomeLink
®
.
. Keep the hand-held remote (gar-
age door opener remote) of the
device you are programming for
use in other vehicles as well as
for future HomeLink
®
program-
ming. It is also suggested that
upon the sale of the vehicle, the
programmed HomeLink
®
buttons
be erased for security purposes.
Refer to “Erasing HomeLink
®
buttons” F3-79.
! Programming a New HomeLink
®
button
1) Indicator Light
2) HomeLink
®
buttons
1. Press and release the HomeLink
®
button that you would like to program.
The HomeLink
®
indicator light will flash
orange slowly (if not, refer to “Erasing
HomeLink
®
buttons” F3-79.
1) Garage door opener remote
2. Position the hand-held remote (garage
door opener remote) 1 to 3 inches (2 to 8
cm) away from the HomeLink
®
button that
you would like to program.
NOTE
Some hand-held remotes (garage door
opener remotes) may actually train
better at a distance of 6 to 12 inches
(15 to 20 cm). Keep this in mind if you
have difficulty with the programming
process.
3-76
To Next Page
Loading...
