32
Setting Route
■ “Point of Interest” method
You can use a selection from the “Point of Interest” listing as your destination or a waypoint.
1
Enter the name of the desired point of interest and select .
2
Select the desired point of interest from the list.
: Use this key to display up to five previous suggestions.
: Use this key to display the previous suggestion.
: Use this key to display the next suggestion.
: Use this key to display up to five of the next suggestions.
First, choose either of the two procedures below to follow the “point of interest” method.
• Press the button or select , select (destination entry), and then select (point of interest).
• Press the button and select (point of interest).
To Next Page
Loading...
