SUBITO ARGON 18 - Seat Post Assembly; Prepare Seat Post Clamp; Adjust Saddle Angle

15
8. Seat Post Assembly
b
a
4
4Nm
4
3Nm
3Nm
2
2Nm
3
3Nm
5
9.5Nm
4
5Nm
2
HT
8
12Nm
8
35Nm
2.5
2Nm
2
0.5-1Nm
40Nm
4Nm
T25
T25
The seat post is supplied fully assembled.
1. Unscrew both bolts slightly until the
top clamp (a) and the cradle (b) are
separated enough to insert the saddle
rail. Do not unscrew the bolts
completely.
2. Apply grease on the thread
of each bolt.
3. Screw both bolts in order
to adjust the angle of the saddle
and clamp the rail.
4. Tighten the rear bolt to 9.5Nm.