7
Battery Monitor
3-Position Slide Switch
The internal 9V battery is monitored at both power up and during use� The
user will be alerted when the battery voltage becomes low� When the battery
becomes too low to reliably operate the pedal, True Bypass is activated�
Upon powering up the pedal, the battery voltage is measured� If the voltage
is at a low voltage (4�5V), the LEDs will flash 3 times to alert the user� Normal
operation will then resume� Should the battery fail completely (<4V), Eclipse
will switch to true bypass mode and the LEDs will begin to flash� This will en-
sure that the signal continues uninterrupted and undistorted�
At the top of the pedal between the Input and Output jack is a 3 position tog-
gle switch�
• When pushed towards Channel 1, the pedal powers on with Channel 1
activated�
• When pushed towards Channel 2, the pedal powers on with Channel 2
activated�
• When set to FL (center), the pedal will accept external control via the FX
LINK jack, and will also power on with neither channel activated�
To Next Page
Loading...
