Need help?Do you have a question about the Suhr Discovery and is the answer not in the manual?
General| Type | Delay Pedal |
|---|---|
| Technology | Analog |
| Expression Pedal Input | Yes |
| Power | 9V DC |
| Current Draw | 300mA |
| Bypass | True Bypass |
| Input Impedance | 1MΩ |
| Weight | 1.5 lbs |
| Controls | Time, Mix, Feedback, Tone, Level |
| Inputs | 1 x 1/4" |
| Outputs | 1 x 1/4" |
Introduces the Suhr Discovery Analog Delay pedal, highlighting its features and design philosophy.
Defines key audio signal terms: Signal, Dry, Wet, and Repeats.
Explains Beats Per Minute (BPM), Modulation, and MIDI terminology.
Details the 7 Segment Display, Preset/Select buttons, and Up/Down buttons.
Explains the functions of the Mix, Lo Cut, and Hi Cut knobs.
Describes Bypass LED, switches, Time Division LEDs, Division Button, and Regen Knob.
Details Time, Modulation Depth/Speed, Waveform selection, and Tempo LED/Switch.
Details the 18VDC Power Input and External Switch (TRS 1/8").
Explains the TAP External Switch (TS 1/4").
Covers Output, Expression Pedal, Input, MIDI In, and MIDI Out/Thru jacks.
Details the functions of the Bypass and Tap Tempo foot switches.
Adjusting the primary delay parameters: Mix and Time (ms/BPM).
Controlling feedback, high frequencies, and low frequencies for tone shaping.
Adjusting modulation depth/speed and selecting delay time divisions.
Selecting, editing, and saving presets using dedicated buttons and navigation.
Tip for efficient adjustment of settings using the Up & Down arrow buttons.
How to select, edit, and save custom delay presets on the pedal.
Procedure for mapping an expression pedal to control delay parameters.
Important notes on preset editing and how to erase unwanted presets.
Restoring factory defaults and operating the pedal in Live Preset Mode.
Procedure to set the Discovery Delay's MIDI channel for communication.
Using MIDI Program Changes (PC#s) to change presets on the Discovery Delay.
Using MIDI Control Changes (CC#s) to control individual knobs and parameters.
Configuring the MIDI OUT/THRU jack for different data transmission modes.
Detailed explanations of the OUT2, OUT3, and OUT4 MIDI output modes.
Configuring the pedal to accept or reject incoming MIDI Control Change data.
Sending patch/controller data, MIDI time sync, and Sysex operations.
Reference table for MIDI Program Changes (PC#s) and their corresponding presets.
Reference table for MIDI Control Changes (CC#s) and their functions.
Procedure to enter and navigate the pedal's global settings menu.
Configure bypass mode and set the MIDI communication channel.
Adjust MIDI sync, CC acceptance, and MIDI Thru/Out port configurations.
Configure external switch, dry signal, and Sysex data transfer operations.
Guide for connecting the Discovery Analog Delay to the front of an amplifier.
Guide for connecting the Discovery Analog Delay to an amplifier's effects loop.
Instructions for controlling the pedal via an external MIDI switching device.
To Next Page
