Suhr Discovery - Detailed Controls; Bypass and Tap Tempo Foot Switches

Discovery Delay – ControlsControls
13
Revision: 1.2 (7/1/2021)
Controls
Bypass Foot Switch
e bypass switch has a few functions
1� To bypass (turn o) the eect
2. To jump to a lower adjacent preset when in “Preset Mode”
3. To select a preset when using an external 2 button foot switch in the EXT SW jack
e Discovery delay has the option to bypass the eect in two ways���
True Bypass (input is physically connected to output, completely taking all circuitry
out of the signal path� is will cut o any echoing repeats)�
Buer Bypass (the input to the delay path is disconnected, leaving the delays to
“Trail” until they decay and leaving the guitar without the eect)�
Refer to the global settings section to select whether the bypass is in True or Buer
bypass modes�
Tap Foot Switch
e tap tempo switch will count the amount of time between switch presses and set
the delay time to that time when division is set to Quarter Note�
How it Works:
e Discovery utilizes an averaging algorithm that will average the last 4 successive
taps, and drop the oldest tap aer 4� If not pressed for longer than 1�5 seconds, the
tap averaging restarts�
Going into “Preset Mode”:
Holding down the Tap switch for 1�1 seconds will put the pedal into “Preset Mode”,
in which the Bypass and Tap switches take on new functions of decrementing and
incrementing which preset you are on� is allows you to easily change presets with
your feet�