Suhr Discovery - Controlling Knobs with MIDI CC; Setting MIDI Out;Thru Modes

Discovery Delay – MIDIMIDI
24
Revision: 1.2 (7/1/2021)
Changing Knob Settings With Control Changes (CC#s)
Every knob and parameter on Discovery can be controlled with Control Changes
(CC#s) being sent from any MIDI device� For a MIDI Table containing the Control
Change numbers and corresponding functions, please refer to page 29� To set Dis-
covery to ignore Controller Changes, refer to page 31�
1. Be sure the Discovery and your MIDI device are transmitting on the same MIDI
channel� For directions on changing Discovery’s MIDI Channel, please refer to page
23�
2. Send Control Change numbers (CC#s) and a value ranging from 0-127 to control
the desired knob� For a MIDI table with CC#s and corresponding functions, refer to
page 29�
Setting MIDI Out/Thru Modes
Discovery has a few modes for the MIDI OUT/THRU jack� On factory settings,
THRU is set to pass data from the MIDI IN jack�
Four dierent OUT modes progressively send more and more data from the Discov-
ery to control other devices and Discovery pedals�
THRU
e MIDI OUT/THRU jack sends a hardware buered copy of the MIDI IN to the
OUT� is is the lowest possibly latency and is recommended when Discovery is not
sending its own MIDI data�
OUT
e MIDI OUT/THRU jack will
1. Pass MIDI data from INPUT to OUT
2. Send PC (Patch Change) data when selecting new presets