Section 7
ILLUSTRATIONS AND PARTS LIST
57
7.3D ENGINE, COMPRESSOR & PARTS -- 260 JOHN DEERE
key part
number description number quantity
1 key, .375 x .312 x 1.80 class #2 02250060---568 1
2 spacer, brake lever 250p 02250064---594 1
3 vlv, air inlet 2 1/2” black (I) 02250088---348 1
4 elbow, 90 3/8”tube x 1/4”npt m 02250099---626 1
5 washer, snubbing vibration mount 02250125---471 4
6 mount, vibration isolator 185 02250125---472 4
7 hose, parcrimp 3/4 x 26 02250126---680 1
8 tee, male branch 3/8”tube x 1/4”npt m 02250136---998 1
9 engine, diesel jd5030tf270 83hp (II) 02250145---523 1
10 support, compressor 12s 260dpq 02250146---142 1
11 support, eng frt rh 185h---260 jd 02250146---143 1
12 support, eng frt lh 185h---260 jd 02250146---144 1
13 rod, speed ctl 185dpq jd 02250148---086 1
14 cylinder, speed air 1---1/16 bore 1’ s tk 02250148---089 1
15 support, low rpm stop 185 jd 02250148---091 1
16 spring, extension spd ctl 185 jd 02250148---166 1
17 fan, 18” blwr cw 185h---260 jd 02250148---498 1
18 valve, eng oil drain m22x1.5 02250148---791 1
19 spacer, fan 3.50lg 2.5bc 185h jd 02250148---826 1
20 clip, spring spd ctl 185---260 02250152---418 1
21 support, spd ctl 185---260 jd 02250152---439 1
22 orifice, .062” x .25m x .25m nptf 027443 1
23 rod end, spherical rh 5/16 040136 1
24 clamp, hose 1/ 2” 043197 1
25 compr model, 12 series unit (III) 1
26 joint, ball female 1/4” l.h. 250011---578 1
27 elbow, 90 1/4t pls x 1/4 npt m 250018---430 1
28 spacer, air conn vlv 250q 250022---950 1
(I) See Section 7.5 for breakdown of the inlet filter. For maintenance on air inlet valve no. 02250088---348,
order repair kit no. 250019---451, or s p ring replacement kit no. 250029---315.
(II) For in depth coverage of the engine, consult t he Engine Operator’s Manual. For maintenance on John
Deere engine oil filter, order replacement filter no. 02250144---815. For maintenance on John Deere en -
gine fuel filter, order replacment filter no. 02250144---814.
(III) There is an exchange program whereby a remanufactured compressor unit can be obtained from Sullair
distributors or the factory at less cost than the owner could repair the unit. For information regarding the
unit exchange program, contact your nearest Sullair representative or the Sullair Corporation.
The shaft seal is not considered part of the compressor unit in regard to t he two year warranty. The
normal Sullair parts warranty applies. For shaft seal repairs consult factory.
(Continued on page 59)
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE SERIAL NUMBER OF COMPRESSOR
To Next Page
Loading...
