kit, repair for thermal valve 049542 (I) 02250105-553 1
kit, repair for thermal valve 250028-762 (II) 02250112-709 1
kit, repair for pressure regulator 02250084-027 (120 Series) 250019-453 1
kit, repair for pressure regulator 250017-280 (160 Series) 250019-453 1
kit, repair for blowdown valve 02250100-042 02250100-042 1
kit, repair for solenoid valve 02250125-657 02250125-829 1
•kit, replacement for solenoid valve coil 02250125-657 02250125-861 1
kit, repair inlet valve 02250143-374 (120 Series) 250031-438 1
kit, repair inlet valve 02250143-377 (160 Series) 250029-249 1
kit, repair for v-type strainer 241771 241772 1
kit, repair for shaft seal (120 Series) 02250050-363 1
kit, repair for shaft seal (160 Series) 02250050-364 1
kit, repair for shaft seal installation 602542-001 1
filter, scavenge line 02250117-782 02250117-782 2
kit, element, replacement for separator/trap 02250144-635
(40, 50HP/ 37KW) 02250144-735 1
kit, repair for moisture separator 02250144-633
(60-75HP/ 45-56KW) 02250144-732 1
kit, repair for moisture separator 02250144-632
(100HP/ 75KW) 02250144-732 1
manual, Sequencing & Protocol (III) 02250139-197 1
fluid, SRF 1/4000 (5 gal/ 19l) 250019-662 (IV)
lubricant, Sullube (Std.) (5 gal/ 19l) 250022-669 (IV)
lubricant, 24 KT (5 gal/ 19l) 02250051-053 (IV)
lubricant, Sullube (Std.) (5 gal/ 19l) 250022-669 (IV)
lubricant, Food Grade CP-4600-32-F (5 gal/ 19l) 250029-008 (IV)
(I) Used on standard compressors, and compressors < 150psi/ 10.3 bar.
(II) Used on all 24KT and high pressure compressors >
150psi/ 10.3 bar.
(III) This document is required to program your personal computer to communicate with the Supervisor
Controller panel.
(IV) For proper amount of fluid fill, please consult Lubrication Guide in Section 3, Specifications.
Mixing of other lubricants within the comperssor uit will void all warranties
PLEASE NOTE: WHEN ORDERING PARTS, ALWAYS INDICATE SERIAL NUMBER OF COMPRESSOR
9.2 RECOMMENDED SPARE PARTS LIST
DESCRIPTION KIT NUMBER QTY
Section 9
ILLUSTRATIONS AND PARTS LIST
44