Sullair LS-25 - Section 6 SUPERVISOR; Supervisor System Overview and Operation; Supervisor Parameter Setup and Controls; Supervisor Maintenance and Daily Checks

TABLE OF CONTENTS
Section 6 PAGE
SUPERVISOR 39 6.9 MAINTENANCE INTRODUCTION
(CONT.) 40 6.10 DAILY OPERATION
Section 7
MAINTENANCE 41 7.1 GENERAL
41 7.2 DAILY OPERATION
41 7.3 MAINTENANCE AFTER INITIAL 50 HOURS OF
OPERATION
41 7.4 MAINTENANCE EVERY 1000 HOURS
41 7.5 PARTS REPLACEMENT AND ADJUSTMENT PROCEDURES
41 AIR FILTER MAINTENANCE
42 FLUID FILTER MAINTENANCE
42 SEPARATOR ELEMENT MAINTENANCE
43 CONTROL SYSTEM ADJUSTMENT
44 SULLICON ACTUATOR MAINTENANCE
45 SHAFT COUPLING MAINTENANCE- 150HP/ 112KW
46 DRIVE COUPLING DISASSEMBLY AND REMOVAL-
200HP/ 149KW
46 7.6 TROUBLESHOOTING INTRODUCTION
47 7.7 TROUBLESHOOTING GUIDE- ELECTRO-MECHANICAL
49 7.8 TROUBLESHOOTING GUIDE- SUPERVISOR
51 7.9 CALIBRATION
Section 8
ILLUSTRATIONS 53 8.1 PROCEDURE FOR ORDERING PARTS
ANDPARTS LIST 53 8.2 RECOMMENDED SPARE PARTS LIST
54 8.3 MOTOR, COMPRESSOR, FRAME AND PARTS
56 8.4 AIR INLET SYSTEM
58 8.5 COOLING & LUBRICATION- AIR-COOLED
60 8.6 COOLING & LUBRICATION- WATER-COOLED