INSTALLATION, START-UP & MAINTENANCE MANUAL
MODEL NO.: SD-220 TO SD-600- DDS OPTION
REV 0 – May 24,,.2001
7
SECTION 1
CAUTION!
•
Never make structural changes to the adsorption dryer!
•
Only use original spare and accessory parts!
•
Never weld on a pressure vessel or change it in any way!
Carry out maintenance work only when the adsorption dryer is
switched off, is depressurized and disconnected from the electric
power supply.
* Advices
Refer to the desiccant material safety data sheet (MSDS) when
installing or disposing of desiccant.
DANGER!
Wear protective goggles when working with the desiccant!
* Advices for protection
•
If desiccant comes into contact with the eyes, rinse eyes
immediately with a lot of clear water.
•
If the desiccant is spilled, clean up without causing swirls of dust.
•
In case of fire, there is no restriction on the use of fire extinguishing
material; the reaction with water and foam is defined as strong.
•
A mask must be worn.
1.3 PERSONNEL QUALIFICATION
The personnel involved in operation, maintenance, inspection and assembly must
have the corresponding qualifications to do this work. Areas of responsibility and
supervision of the personnel must be precisely established by the operator. Should
the personnel not possess the necessary knowledge, then they must be trained and
instructed. If need be, this training may be carried out by the manufacturer / supplier
at the request of the operator of the adsorption dryer. Further, the operator is to
make sure that the personnel completely understand the contents of the technical
manual.
To Next Page
Loading...