Section 7
MAINTENANCE
25
element no. 405158. Below you will find procedures
on how to replace the air filter element.
AIR FILTER ELEMENT REPLACEMENT
1. Clean the exterior of the air filter housing.
2. Remove the air filter cover by loosening the wing
bolt securing the cover.
3. Remove element and clean interior of housing
using a damp cloth. DO NOT blow dirt out with
compressed air.
4. At this time, replace the element.
5. Re-assemble in reverse order of the disassem-
bly.
ELEMENT INSPECTION
1. Place a bright light inside the element to inspect
for damage or leak holes. Concentrated light
shines through the element and locates any
holes.
2. Inspect all gaskets and gasket contact surfaces
of the housing. Should faulty gaskets be evi-
dent, correct the condition immediately.
3. If the clean element is to be stored for later use,
it must be stored in a clean container.
4. After the element has been installed, inspect and
tighten, if necessary, all air inlet connections
Figure 7-3 Air Filter (P/N 408399)
(100-150HP/ 75-112KW)
*Replacement Element Kit P/N 405158
Figure 7-4 Air Filter (P/N 409264 or P/N 02250140-798) Consult Charts Below to Determine Proper Filter
AIR FILTER NO. 409264:
HP/KW L H HH XH
100/75 X X
125/93 X X
USE:
*Primary Element no. 409853
**Secondary Element no. 409854
AIR FILTER NO. 2250140-798:
HP/KW L H HH XH
125/93 X X
150/112 X X X X
200/187 X X
USE:
*Replacement Element no. 02250135-150
To Next Page
Loading...
