Installation
3. Upon receipt, inspect Tip-N-Tell Sensor on Package for Activation
3.1 The Tip-N-Tell sensor mounted on the shipping container package surface should be
checked upon receipt and before unpackaging to verify the “Compressor Unit
shipping container” was NOT tipped or mishandled during transport.
3.2 If activated, Tip-N-Tell sensor turns blue in the arrow as shown below. Proceed with
internal inspection.
Non-Activated (Good) Activated (Not Good)
Unpackaging and Product Inspection Instructions
1. Unpackaging Instructions
1.1 Remove the straps around the package.
1.2 Remove the Packaging Cover Shell and Top Inside Cushions.
1.3 Insert and tighten the three (3) furnished eyebolts into the top of the compressor.
See Figure 3.
PREVENT EQUIPMENT DAMAGE. Use properly rated commercial
equipment for lifting or moving the compressor. Make sure compressor is
held in a balanced and stable position. Follow all applicable safety
r overhead material transport.
1.4 Carefully lift the compressor off the wooden base.
1.5 Retain the reusable shipping container parts for possible reuse. This includes the
wooden base with Ethafoam cushion blocks, the packaging cover shell and the top
inside cushions.
2. Inspect the Tip-N-Tell Sensor on Compressor Unit for Activation.
2.1 Check the Tip-N-Tell sensor mounted on the compressor rear panel. If the Tip-N-
Tell sensor shows no mishandling and there is no apparent physical damage, skip
Steps 2.2 and 2.3 and proceed to the section Compressor Location.
If the Tip-N-Tell sensor indicates mishandling (arrow dot is red), proceed to either Step
2.2 or 2.3:
To Next Page
Loading...
