Installation
Electrical Supply Connection - Field Wiring Instructions
Tool required: #3 Phillips screwdriver
5 mm Hex driver
The FA-20L compressor must be installed in a circuit capable of supplying the specified voltage
and power. The wiring method used for connection to the front panel power connector must
meet applicable codes.
AVOID ELECTRIC SHOCK. All electrical supply equipment must meet
applicable codes and be installed by qualified personnel. Permit only qualified
electrical technicians to open electrical enclosures, to perform electrical checks
or to perform tests with the power supply connected and wiring exposed. Failure
to observe this warning can result in serious injury or death.
Connect mains power supply cable into the mains power receptacle on the front panel and
fasten cover with attached screws. See Figure 4 below.
Figure 5 Connect Mains Power Supply Cable to Mains Power Receptacle
To Next Page
Loading...
